InRoads Tip: Deleting Superelevation

In InRoads, superelevation is now controlled by a superelevation diagram in Roadway Designer. The diagram can be created using the Superelevation Wizard, or you may create the super control lines individually. But what about when you need to change the diagram due to a design change, or just an error? Depending on the extent of the change, sometimes it’s easiest to just start over. You can follow the InRoads Tip below to quickly remove all superelevation and corresponding Point Controls so that you can re-run the wizard or recreate the control lines.

InRoads Tip Superelevation I

InRoads Tip Superelevation II

InRoads Tip Superelevation III

Share the knowledge:
  • Facebook
  • Twitter
  • LinkedIn
  • StumbleUpon
  • Google Buzz
This entry was posted in InRoads and tagged , . Bookmark the permalink.

Comments are closed.